2803-B Center-Take-Off Pulley
This pulley is used when it is necessary to route the operating cables perpendicular to the track at track elevation. Ideally, the CTO pulley should be located a minimum of 4' from the end of the track or the nearest dead-end pulley. Add 1 each Model 2804 dead-end pulley to the system when using this device.
Formed steel construction with powder coated finish. Equipped with 2 nylon wheels with oil-impregnated sleeve bearings.
Extends 5" from side of track.
NOTE: Additional muling pulleys may be required to mule operating lines to a machine or floor pulley.
Weight: 1 – 5 lbs. 12 oz.